Publicité
USE ZONEBOOST™
During your session, you can increase the intensity of a single zone with the ZoneBoost feature.
ZoneBoost is designed to be used when you want extra attention in a specific area. ZoneBoost will add
an extra 60 seconds of massage time, as well as 10 mmHg increased pressure, in the selected zone.
ZoneBoost can be enabled before or during a session. Only one zone can be boosted at a time. To boost
a zone press the ZoneBoost button until the display shows the number of the zone you want to boost. To
disable ZoneBoost press the ZoneBoost button until the display shows " – ".
The zones on the attachment are numbered in ascending order from distal zone to proximal zone.
Zone 1 would be your foot/ankle, Zone 2 would be your calf, Zone 3 your knee, Zone 4 lower quad and
Zone 5 upper quad.
START THE SESSION
To start the session, tap the Start/Stop button.
PATENTED NORMATEC PULSE MASSAGE PATTERN
Before the patented Normatec Pulse massage pattern begins, you will experience a pre-inflate cycle,
during which the inflatable boots are calibrated to your exact body shape. Once the pre-inflate cycle is
complete, the patented Normatec Pulse massage pattern will begin by compressing your feet. Similar
to the kneading and stroking performed during a massage, each zone of the boots will first compress in
a pulsing manner and then release as the compression pattern works its way up your leg. When the top
zone completes its massage, there will be a brief rest period and then the cycle will begin again. This will
repeat until the session time runs out. When the session is resumed after a pause, the device will perform
a pre-inflate cycle before continuing.
STOP OR PAUSE THE SESSION
To stop the session at any time, tap the Start/Stop button. This will pause the session. To restart your
paused session, tap the Start/Stop button again. If you are done using the device, turn off the device by
pressing the power button and remove the inflatable boots from your limbs.
To remove the boots, fully unzip the garment and then remove.
FINISH THE SESSION
The session will continue massaging until time runs out and the display reads Finishing Cycle. The device
will continue until the current cycle is finished. When the session is completed, turn off the control unit by
pressing the power button and remove the boots from your limbs.
To remove the boots, fully unzip the garment and then remove.
TURN OFF THE CONTROL UNIT
To turn off the device, press the power button and confirm that the LED indicators and display is off.
USING HYPERSYNC™
Your Normatec Elite devices arrive paired, which means they will inflate and deflate on the same cycle.
To unpair devices, press and hold the Start / Stop button on either device until the device screen reads
"Unpaired!" and the white pairing indicator light is no longer illuminated. To pair your devices, turn on both
devices by pressing and holding the power (ON/OFF) button. Then press and hold Start / Stop button on
either control unit until the display screen says "Pairing!" Finally, press and hold the Start / Stop button on
the other device until both devices say "Pairing!" and the white pairing indicator light is illuminated.
CONNECTING TO THE HYPERICE APP
Download the Hyperice App from the App Store or the Google Play Store. To connect your device to
the Hyperice App via Bluetooth® make sure that your device is turned on, Bluetooth® is turned on in
your phone, and your device is within range of your phone. If prompted, tap "Scan for Devices." Select
your device when it pops up on the screen. The blue LED on the control unit will light up when you have
successfully connected to your mobile device. Once you pair your Normatec Elite, HyperSmart™ will allow
you to automatically start your session and control the within the Hyperice App.
CYBERSECURITY
It is recommended to configure the Hyperice App for automatic updates to ensure cybersecurity. It is also
recommended to keep your Operating System up to date and to configure your Operating System for
automatic updates.
Publicité
