Publicité
3.5 Connect the Doorbell Wires to the Doorbell
Connect the wires to the terminals at the back of the doorbell, then tighten
the terminal screws. Wire can connect to any terminal.
What you need: Wires and Wire Nuts (Optional), Video Doorbell, Philips-
head Screwdriver
eufy Security Video
Extension Wires and
Doorbell Dual (Battery)
Wire Nuts (Optional)
Model: T8213
Note:
• To prevent short-circuiting, make sure the wires are not touching each
other after connecting them to the terminals.
• If the wires are too short, use the extension wires and wire nuts provided
to make them longer. Use electrical wiring tape instead if there is no more
space on the wall for wire nuts.
24 EN
Phillips-Head
Screwdriver
(Not provided)
3.6 Mount the Doorbell on the Bracket
Align the doorbell on the bottom, and then move it into place on top. Press the
doorbell down until it clicks.
3.7 Restore Power
Switch the master circuit breaker back to ON.
You're all set!
If you want to detach the doorbell or recharge it, please refer to the
corresponding sections.
ON
ON
EN 25
Publicité
