Publicité
Troubleshooting
Check following points before calling or arranging for repair.
Problem
Even though
the tumbler is
▶
twisted to
"ON" direction,
the appliance
does not start
blending.
▶
The blade is
idling.
▶
The appliance
stops during
blending.
▶
There is
abnormal
noise or
vibration.
EN16
Cause and Action
The tumbler unit is not attached with the motor housing
●
properly.
➡ When attaching it, make sure the marks on tumbler
base and motor housing have been aligned, then twist
it firmly until you hear a "click" sound.
The tumbler base is not attached tightly.
●
➡ Assemble it tightly.
The power plug is disconnected.
●
➡ Insert the power plug into outlet firmly.
Ingredients are stuck around the blade.
●
➡ Remove all ingredients and then replace them.
The liquid amount is not enough.
●
➡ Add more liquid.
Too many ice cubes.
●
（e.g. juice with a lot of ice）
➡① Twist the tumbler back to "OFF" direction, remove
tumbler after rotation stops completely.
② Shake the tumbler gently.
• If it happens again, reduce the ingredients.
The overloading protection device is activated.
●
• Prohibited ingredients are added.
• Too many ingredients are used.
• Ingredients are too large.
• Ingredients are too hard. (e.g. shaved ice)
• There is abnormal noise or large vibration.
➡ Refer to "Overloading Protection" for inspection.(P. EN17)
If prohibited ingredients are used, remove them.
Too many ingredients.
●
➡ Twist tumbler to "OFF" direction and reduce ingredient amount.
The tumbler unit is not assembled firmly.
●
➡ Assemble it firmly. (P. EN10)
Publicité
