1
Ensure to assemble the tumbler unit
properly.
2
Insert the power plug.
Align the ▲ on the motor housing with
the ▽ on the tumbler base.
3
Hold and twist the tumbler to "ON" direction to
start blending.
(see Figure 2)
Blending time (approximately) : 1 min -1 min 30 s
●Hold the tumbler firmly during use.
4
Twist tumbler to "OFF" direction
to stop blending.
5
After the blade stops rotating, remove the
tumbler unit from motor housing.
6
Turn the tumbler upside down and
remove the tumbler base.
7
Pour out the mixture or attach the lid.
Pull out the power plug after use.
●Make sure the lid gasket and opening cap
gasket are properly positioned when using lid.
● When using lid (with opening cap), do not turn it
up-side-down or tilt it, otherwise the ingredients
may spill out from the drinking spout.
●Do not use the lid with opening cap to blend
sticky or low moisture content ingredients, as
they are hardly to pour through the drinking spout.
●Do not use a metal spoon or spatula when
taking out the mixture. Using narrow rubber
spatula with curved head which less than 4 cm
width is recommended. (Commercial sales)
Recipes
Put the ingredients in the order from top to bottom.
Walnut Apple Smoothie
Blending time (approximately): 1 minute
Milk
80 mL
approximately 4 pieces (8 g)
Walnut
Apple (medium)
approximately
/
1
Honey
teaspoon
2
Cinnamon powder Appropriate amount
Hot drink: Pour it into a heat-resistant container after
blending, and then heat it in a microwave before drinking.
(see Figure 1)
(see Figure 3)
Kiwi fruit and celery smoothie
Blending time (approximately): 1 minute
Cold water
Kiwi fruit
(100 g)
/
2
5
Banana
Celery
Figure 1
②
①
②
Clik
The blade rotates.
Figure 3
②
①
Drinking spout
Opening
cap gasket
Lid gasket
4 cm以下
less than 4 cm
80 mL
45 g
60 g
30 g
①
Figure 2
Stop
EN13