Publicité
DELAY START button
This button allows to delay the start of the
programme from 30 minutes (1 hour on
some models) to 24 hours in 30 minutes
intervals (1 hour on some models).The
delay selected is shown on the display.
After pressing the START/PAUSE button
the time showed decrease minute after
minute.
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME CYCLE SELECTION button
It's possible transform a cycle from
automatic to programmed, up to 3
minutes after the start of the cycle.
The progressive pressure increases the
time in 10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
DRYING SELECTION button
This button allows to set the desired
dryness level editable option up to 3
minutes after the starting of the cycle:
Ready to Iron: it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger: to get garment ready to
be hang.
Dry wardrobe: for laundry that can be
directly stored.
Extra-dry: to get completely dry
garments, ideal for full load.
This appliances is equipped with Drying
Manager function. On automatic cycles,
each level of intermediate drying, prior to
the reaching the selected one, is indicated
by flashing the light indicator corresponding
to the degree of drying reached.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
RAPIDS button
It's possible to switch an automatic
program to rapid program, up to 3
minutes after the start of the cycle. The
progressive pressure increases the time
(30-45-59 minutes).
After this selection to reset the automatic
drying functioning it is necessary to
switch off the dryer.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
ANTI CREASE button
During the cycle the option sets alternate
movements of the drum to reduce the
folds and automatically sets the drying
level to "Ready to Iron". Moreover this
option activate an anti-creases movement
of the drum pre cycle in case of activation
of the delay and at the end of drying
cycle. It is activated every 10 minutes, up
to 6 hours after the end of the drying
cycle.
To
stop
the
programme selector to OFF. Useful when
it's not possible to remove immediately
the laundry.
START SMART TOUCH
Simultaneously pressing the START/PAUSE
and ANTI CREASE buttons allows a
previously downloaded cycle to be started
whilst the Smart Touch position is selected
on the programme knob (for downloading
cycles from the App see the relevant
section of this user manual).
68
movements
set
the
Publicité
