Publicité
WARNING
Don't touch the buttons while inserting
the
plug
because
calibrates the systems during the first
seconds: touching the buttons, the
machine couldn't work property. In
this case, remove the plug and repeat
the operation.
PROGRAMME SELECTOR with
OFF position
Rotating the programme selector in both
directions it's possible to select the
desired drying programme.
To cancel the selections or switch off the
appliance rotate the programme selector
on OFF (remember to unplug the appliance).
START/PAUSE button
Close the porthole BEFORE pressing
the START/PAUSE button.
To start the selected cycle with the preset
parameters, press START/PAUSE. When
the programme is running, the display will
show the time to elapse.
Moreover, if you want to modify the
chosen programme, press the desired
options
buttons,
parameters and then press START/
PAUSE button to start the cycle.
Only the options compatible with the
set programme can be selected.
After switching on the appliance, wait a few
seconds for the programme to start running.
PROGRAMME DURATION
When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
the
machines
modify
the
default
Once the programme has started you will
be kept informed constantly of the time
remaining to the end of the drying cycle.
The appliance calculates the time to the
end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to the
humidity level of the load.
PROGRAMME END
"END" ("End" on some models) will
appear in the display at the end of the
programme, it is now possible to open the
door.
At the end of the cycle, turn off the
appliance by turning the programme
selector to the OFF position.
The
programme
ALWAYS be put in the OFF position at
the end of the drying cycle before a
new one can be selected.
PAUSING THE MACHINE
Keep the START/PAUSE button pressed
for about 2 seconds (the residual time
display will flash, showing that the
machine is paused).
Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
To cancel the programme, turn the
programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
67
selector
must
Publicité
