PE 6102M
MOBILE SCISSOR LIFT DUAL CYLINDER LOW RAISE 230V 3T
A (mm)
B (mm)
C (mm)
D (T)
E (T)
F (T)
G (T)
1600
1800
110
1,8
1,2
1,8
1,2
USE
Raising the lift
1.Make sure that you have read the operation manual before operation.
2.Always lift the vehicle at the manufacturer recommended points.
3.Position the vehicle right on the center of two platforms.
4.Turn on the switch.
Raise the lift by pressing UP button on control box until the pads
touch firmly the right points and recheck if the vehicle is secure.
5. Check the security of vehicle, then perform maintenance or repair
work.
Lowering the lift
Press down button to lower the lift.
The lift will raise a little to release the lock then goes down.
MAINTENANCE
We will give the user one-year warranty of quality for the machine. If something wrong with the
machine within the term of service, we will repair or replace the product according to the user's
demand. The manufacturer will not take any responsibility for improper installation and operation
overload running wrong concrete ground (that can not meet the requirements in the manual),
normal mechanical abrasion and insufficient maintenance. The warranty will be carried out on the
basis of the type and serial number of the equipment. Therefore, the users shall provide them to
the manufacturer without fail.
The several pieces of maintenance operations to be carried out are described below. A low
operating cost and a long life of the machine are from routine observation of there operations.
The listed intervention times are given for information and they refer to normal operating conditions.
They can change according to the kind of service, environment, frequency of use, etc.
1. Daily pre-operation check
The user should perform daily check. Daily check of safety latch system is very important – the
discovery of device failure before needed could save you from expensive property damage, lost
production time, serious personal injury, even death.
• Check safety lock audibly and visually while in operation