Publicité
PE 6102M
MOBILE SCISSOR LIFT DUAL CYLINDER LOW RAISE 230V 3T
SPECIFICATIONS
- lifting height: 115-1000mm
- lifting time: +/- 50s
- lowering time: +/- 30s
- track width/length: 460/1410-2010mm
- control console
- drive power: 3kW
- drive voltage: (3 ~) 400/50 V/Hz
- emergency lowering system in case of power failure
- intermediate stop 20 cm above ground for operator safety and anti-crushing audible signal
- engine protection
- rack and pinion safety
- electric lock release (no pneumatic power supply required)
INSTALLATION
Avant installation
1. Identify the components and check for shortages. Contact us immediately if shortage discovered.
Installation, adjusting and testing operations are to be performed by qualified staff only.
3. The lift must be installed on a level concrete floor, having minimum thickness of 20cm and an
extension of at least 3.65m from the wall.
4. The lift installation concrete surface must be relatively smoothes, leveled in all directions
5. After unloading the lift, place it near the intended installation location.
Remove the shipping brands and packing materials from the unit.
Remove the packing things.
Space required
Prepare ground base according to the SPACE REQUIREMENT
DRAWING.
The concrete's thickness should be ≥200mm and the error of
levelness should be ≤5mm when the ground condition is good.
Publicité
