Publicité
PE 6102M
MOBILE SCISSOR LIFT DUAL CYLINDER LOW RAISE 230V 3T
Electrical system
Any work on the electrics must be carried out by qualified personnel only.
Equip the electric system of installation place with effective ground circuit.
The electric system adjusting must be made in accordance with the nameplate showing.
Connecting
You may start to connect oil hose, air supply and power after the above preparations.
1. Oil hose connecting
See the hydraulic diagram for oil hose connecting. Make sure that no soil or other dirty things into
the pipe.
2. Air hose connecting
See pneumatic diagram for air hose connecting
3. Power supply connecting
Connect power line according to the electric diagram
4. Refill the tank
Pour 6 liters of L-HM32 anti-wear hydraulic oil (provided by user) into oil tank. The highest level
should be 10mm from the top of the tank and the lowest level should be 40mm from the top of
the tank (check with the detective ruler on the oil pouring air cover).
5. Base frame fixed
The lift is design also for mobile use, means that you may use it without fixing. If need fixing, please
refer to the space required drawing.
6. Loading test
This step is very important to check if there is any leakage of hydraulic line connectors or air
hose. If there's no abnormal noise or leakage after running two or three times, run with load never
exceeding 2500kg at a low height.
Then raise higher gradually.
OPERATION
WARNING: DO NOT PLACE ANY VEHICLE ON THE LIFT BEFORE TRIAL OPERATION. RAISE
THE LIFT UP AND DOWN SEVERAL TIMES TO INSURE LATCHES CLICK TOGETHER AND AIR
EXHAUSTED FROM THE CYLINDERS.
Before operation :
a. Check all the pipelines and joints before use. The machine only can be used after there is not
any leakage.
b. The lift, if its safety device malfunctions, shall not be used.
c. The machine shall not raise or lower an automobile if the center of gravity of automobile is not
within the supporting range of the supporting device. Otherwise, the manufacturer will not bear
any responsibility for the consequence resulted from the operation above mentioned.
d. The staff or operators shall be in a safe position when the machine raise or lower.
e. When the lift with vehicle on reaches a desired height, first of all, the main switch must be turned
off before the automobile is repaired so as to prevent non-operator or unauthorized person from
pressing the start switch.
Publicité
