Publicité
Troubleshooting
Problem
Is noisy.
Dries unevenly.
Has odors.
Lint on clothes.
Items still wrinkled after
Wrinkle Prevent (Wrinkle
Away, Wrinkle Release).
Water drips from the nozzle
when the Steam cycles
starts.
56
English
Untitled-1 56
Untitled-1 56
• Check the load for objects such as coins, loose buttons, nails, etc.
Remove promptly.
• It is normal to hear the dryer gas valve or heating element cycle on
and off during the drying cycle.
• Make sure the dryer is leveled properly as outlined in the installation
instructions.
• It is normal for the dryer to hum due to the high velocity of air moving
through the dryer drum, fan, or exhaust system.
• Seams, pockets, and other similarly heavy areas may not be
completely dry when the rest of the load has reached the selected
dryness level. This is normal. You can choose a higher dryness level or
a cycle that involves a higher dryness level.
• If one heavy item is dried with a light weight load, such as one towel
with sheets, it is possible that the heavy item will not be completely
dry when the rest of the load has reached the selected dryness level.
• For the best drying results, dry heavy items and light weight items
separately.
• Household odors from paint, varnish, strong cleaners, etc. may enter
the dryer with the surrounding room air. This is normal as the dryer
draws the air from the room, heats it, pulls it through the tumbler, and
exhausts it outside.
• When these odors linger in the air, completely ventilate the room
before using the dryer.
• Use the REFRESH cycle. If odors persist, wash and dry the items again.
• Make sure the lint filter is cleaned before every load. For clothes that
naturally build up lint, clean the filter during the cycle.
• Some fabrics are lint producers (for example, a fuzzy white cotton
towel) and they must be dried separately from clothes that are lint
trappers (for example, a pair of black linen pants).
• Divide larger loads into smaller loads for drying.
• Check pockets thoroughly before drying, then dry clothes.
• Remove lint inside the drum before drying a load.
• Small loads of 1 to 4 items work best.
• Load fewer items. Load similar-type items.
• Take out the items immediately after drying is complete.
• This is steam condensation. The dripping water will stop after a short
time.
Action
2024-09-03
2024-09-03
6:20:19
6:20:19
Publicité
