Publicité
Maintenance
Keep the dryer clean to prevent decreased performance and to lengthen its life.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing.
Service Personnel - Do not contact the following parts while the appliance is energized: Control board and
inlet valve.
Vent sensor
The dryer features a vent sensor that detects and notifies you when it is time to clean the ductwork. The
indicator lets you know the status of the duct.
Level
Indicator
0
Off
1
On
Blinking with
2
the alarm
If the vent sensor detects a level 2 state, the
of the current cycle, and the blinking will continue for 3 hours. If you press Power or open the door, the
dryer powers off immediately.
NOTE
• For duct installation, see " Exhaust ducting guide".
• The dryer may keep running even if the duct is clogged, but the drying time will be extended.
• If the indicator turns on for the first time and is solid (not blinking), check and clean the lint filter and/
or duct.
• If the indicator turns on again later, it is because the duct is installed or connected with some
restrictions (it's too long or has too many bends). This is not a system failure. However, drying time may
be extended or the drying performance may be degraded.
Untitled-1 53
Untitled-1 53
Status
The ductwork is not clogged.
• The duct or lint filter is clogged.
• The pressure applied to the duct
is high because the duct is too
long or bent.
• The duct or lint filter is severely
clogged.
• The pressure applied to the duct
is very high because the duct is
too long or bent.
starts to blink with a 5-second alarm after the completion
Action
• Check the lint filter or duct and
clean if necessary.
• Check the duct connections and
shorten or straighten the duct if
necessary.
• Check and clean the lint filter or
duct and make sure they are not
clogged.
• Check the duct connections and
shorten or straighten the duct
work.
English 53
2024-09-03
2024-09-03
6:20:18
6:20:18
Publicité
