Publicité
3.1.18 W
. DO NOT move the appliance by pulling on the ELECTRIC CABLE.
arning
3.1.19 W
. DO NOT allow vehicles to drive over the high pressure hose.
arning
3.1.20 W
. DO NOT move the appliance by pulling on the high pressure hose.
arning
3.1.21 W
. When directed towards tyres, tyre valves or other pressurised components,
arning
the high pressure jet is potentially dangerous. DO NOT use the rotating nozzle kit,
and always keep the jet at a distance of at least 30 cm during cleaning.
3.1.22 W
. The use of non-original accessories and any other spare parts not specifically
arning
intended for the model in question is prohibited. All modifications to the appliance
are prohibited; any modifications shall render the Declaration of Conformity null and
void and relieve the manufacturer of all liability under civil and criminal law.
3.2
SAFETY "MUSTS"
3.2.1 W
. All electrical conductors MUST BE PROTECTED against the water jet.
arning
3.2.2 W
. The electric supply connection must be made by a qualified electrician
arning
and comply with IEC 60364-1. Either a residual current device that will cut off
the power supply if the leakage current to earth exceeds 30 mA for 30 ms or a
ground fault interrupt device must be installed.
3.2.3 W
. DURING start-up, the appliance may cause network noise.
arning
3.2.4 W
. Use of a residual current breaker (RCB) will provide additional protection
arning
for the operator (30 mA).
3.2.5 W
. Models supplied without plug must be installed by qualified staff.
arning
3.2.6 W
. Use only approved electrical extension leads with suitable conductor cross-section.
arning
3.2.7 W
. Always turn off the switch when leaving the appliance unattended.
arning
3.2.8
W
. High pressure may cause parts to rebound: wear all the protective
arning
clothing (PPE) and equipment needed to ensure the operator' s safety.
3.2.9 W
. Before doing work on the appliance, REMOVE the plug.
arning
3.2.10 W
. Before pressing the trigger, GRIP the gun firmly to counteract the recoil.
arning
3.2.11 W
. COMPLY WITH the local water supply authority regulations.
arning
Under IEC 60335-2-79, the appliance may only be connected to the mains
drinking water supply if the supply hose is fitted with a backflow preventer valve
with drain facility corresponding to EN 12729 type BA. The backflow preventer
can be ordered from the manufacturer.
(Original instructions)
ENGLISH
11
Publicité
