Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Grip the door on the two outer sides and
close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram). To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
Lamp
Holder
compartment
Lamp
Glass cover
! Do not touch the light bulb directly with your hands.
! Do not use the oven lamp as/for ambient lighting.
Sliding rack kit assembly
A
Left
Right guide
guide rail
rail
B
C
F
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap G 9.
3. Replace the glass cover (see
diagram).
To assemble the sliding racks:
1. Remove the two frames, lifting them
away from the spacers A (see figure).
2. Choose which shelf to use with the
sliding rack. Paying attention to the
direction in which the sliding rack is to
be extracted, position joint B and then
joint C on the frame.
D
! Do not place the sliding racks in position 5.
Automatic cleaning by PYROLYSIS
The cleaning cycle can cause the internal temperature of the oven to reach
500°C. The pyrolytic cycle is activated, burning away food and grime residues.
Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause for concern: this process
is both normal and hazard-free.
Before initiating the PYROLYTIC cycle:
• clean the oven door;
• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where present);
• do not place tea towels or pot holders over the oven handle.
! If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to
cool down.
! The programme may only be started once the oven door has been closed.
To activate the cleaning cycle
1. Press
to switch on the control panel.
2. Press the
icon.
3. Scroll through the menu commands using the control dial, select
PYROLYTIC and press
.
4. The appliance suggests a "NORMAL" pyrolytic cycle, with a duration of 1
hour 30 minutes. Other levels of cleaning may be selected.
• Use the control dial to select one of the following:
- "ECONOMY": duration 1 hour
- "NORMAL": duration 1 hour and 30 minutes
- "INTENSIVE": duration 2 hours.
• Press
again.
5. Press
to begin the PYROLYTIC cycle.
Safety devices
• the door locks automatically as soon as the temperature reaches a high
value; the
icon lights up on the display.
• pressing the
icon cancels the cleaning cycle at any time.
• if a malfunction occurs, the heating elements will be switched off.
• once the oven door has been locked, you cannot change the duration and
end time settings.
3. Secure the two frames with the
guide rails using the holes provided
on the oven walls (see diagram). The
holes for the left frame are situated at
the top, while the holes for the right
frame are at the bottom.
4. Finally, fit the frames on the spacers
A.
:
GB
33
Publicité
Table des Matières
