Publicité
5. Visor
• To remove the visor, carefully loosen the screws on the visor from the provided fixing holes
of the helmet shell (Fig. H). We recommend opening the screws using a small coin. The use
of a screwdriver or other pointed objects may damage the surface of the screws.
• The fixing holes of the visor can be closed with the screws.
Attention: the fixing holes in the helmet may widen due to excessive
use. In this case, the visor must no longer be used.
6. Cleaning and care
• All chemicals, paints and stickers can seriously impair the protective effect of the helmet.
• Only clean your helmet with lukewarm water, mild soap and a soft cloth.
• After every use, leave your helmet exposed to the air in order for it to dry.
• Clean the inner padding with lukewarm water and mild soap and then let it air dry.
7. Disposal
• Please contact your local waste disposal company for the disposal of the helmet.
Key to the symbols
Declaration of conformity (see chapter „Declaration of conformity"):
Products marked with this symbol comply with all applicable European
Community regulations Economic area.
Expiry date
Helmet weight
Date of manufacture
The Seal of Approved Safety (GS mark) certifies that a product meets the
requirements of the German Product Safety Act (ProdSG). The GS mark
indicates that the safety and health of the user are not at risk if the product is
used as intended and if foreseeable misuse of the marked product occurs.
Read the user manual
PO-2023-29_Lidl_BDA Fahrradhelm_SP-141_Inside_LB8 - Lieferländerversion.indd 7
PO-2023-29_Lidl_BDA Fahrradhelm_SP-141_Inside_LB8 - Lieferländerversion.indd 7
Mountain Bike Helmet SP-141
7
GB
IE
11.10.2023 15:29:55
11.10.2023 15:29:55
Publicité
