Publicité
H - POSSIBLE PROBLEMS /
CORRECTIVE ACTION
In case of burn back (ignition under the
burner cap) switch the product off, allow it to
cool down (approximately five minutes), then
reignite the appliance. If the problem of burn
back persists, then please contact your local
Campingaz
representative.
®
The burner does not light up
- Poor gas supply
- Regulator not operating properly
- Pipe, valve, venturi tube or burner holes
obstructed
The burner does not burn smoothly or
goes out
- Check that gas is present
- Check the pipe connection
- Contact your servicing agent.
Unstable blowing flames
- New cylinder may contain air. Allow the
stove to operate and the fault will clear itself
- Residual water, following the washing of
the burner caps
- Contact your servicing agent.
Large plume of flame on the burner surface
- The venturi is obstructed (possibly
cobwebs). Clean the venturi.
- Contact your servicing agent.
Flame at the injector
- The cylinder is almost empty
- Change the cylinder and the fault will
clear itself
- Contact your servicing agent.
Burning leak around a union
- Shut off the gas supply immediately
- Leaking union: tighten nuts or change pipe
- Contact your servicing agent.
Insufficient heat
- Injector or venturi tube obstructed
- Contact your servicing agent.
Burning leak behind the adjustment knob
- Defective valve
- Shut down the stove
- Contact your servicing agent.
- 15 -
GB
Publicité
