Publicité
Fig. 6
R E F I L L I N G C O O L A N T
1.
Connect the coolant hose.
2.
It is necessary to ensure that cap no. 3 is set to „OFF" before topping up the coolant.Make sure
that the hose is filled with coolant.
3.
Set cap no. 7 to „ON" to allow the coolant to be drawn into the radiator.
4.
If the needle of the pressure indicator has dropped to „ZERO", the radiator should be sufficiently
full.
NOTE:
Check again whether the radiator is completely filled with coolant. If this is not the case , top up an
appropriate amount of coolant manually.
8
Publicité
