Publicité
If you run the hood at any speed
level with the aluminium filter fill
warning, the warning will not ap-
pear for as long as the hood is run-
ning. When you turn off the hood,
the fill warning starts flashing
again for 30 seconds.
If you turn off the warning without
cleaning the aluminium filter, the
operating time of 100 hours is re-
set and it starts over. At the end of
the next 100 hours, your hood
warns again.
Carbon filter fill warning (for products with
carbon filter)
The light of Speed 2 key flashes for thirty
seconds after every 100 hours of opera-
tion. In this case, you must replace your
carbon filter. Consult an authorized service
for this. After replacement, the lamp warn-
ing of Speed 2 key does not turn off auto-
matically. This product continues to show
the 30-second warning when the product
switches off after every operation. When
6 Maintenance and Cleaning
6.1 General Cleaning Information
General warnings
• Wait for the product to cool before
cleaning the product. Hot surfaces may
cause burns!
• Do not apply the detergents directly on
the hot surfaces. This may cause per-
manent stains.
• The product should be thoroughly
cleaned and dried after each operation.
Thus, food residues shall be easily
cleaned and these residues shall be pre-
vented from burning when the product is
used again later. Thus, the service life of
the appliance extends and frequently
faced problems are decreased.
• Do not use steam cleaning products for
cleaning.
you touch the Speed 2 key for more than 3
seconds, carbon filter fill warning is reset
and the lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
carbon filter fill warning. When the
power is available, it continues to
warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning starts flashing again for
30 seconds.
If you turn off the warning without
replacing the carbon filter, the op-
erating time of 100 hours is reset
and it starts over. At the end of the
next 100 hours, warning is given
again.
• Some detergents or cleaning agents
cause damage to the surface. Unsuitable
cleaning agents are: bleach, cleaning
products containing ammonia, acid or
chloride, steam cleaning products, de-
scaling agents, stain and rust removers,
abrasive cleaning products (cream
cleaners, scouring powder, scouring
cream, abrasive and scratching scrub-
ber, wire, sponges, cleaning cloths con-
taining dirt and detergent residues).
• No special cleaning material is needed in
the cleaning made after each use. Clean
the appliance using dishwashing deter-
gent, warm water and a soft cloth or
sponge and dry it with a dry cloth.
• Be sure to completely wipe off any re-
maining liquid after cleaning and imme-
diately clean any food splashing around
during cooking.
EN / 15
EN
DE
FR
ET
Publicité
