Publicité
EN
•
Detach the rod (G) from the pin/gasket
assembly (I) (Fig 25).
•
Disassemble (by pulling) the pin (L) from the
gasket (M) (Fig 26).
Wash the disassembled components with a
sanitising detergent solution, rinsing thoroughly
with clean hot water.
Reassemble the tap by reversing the disassembly
instructions.
•
To fit the lever (F) push the rod (D) from the
inside until the guides protrude; then insert the
lever (F) and slowly release the rod (D)
(Fig 27).
8
CN219_ML_A5_v4_20241030.indb 8
CN219_ML_A5_v4_20241030.indb 8
•
To fit the tap correctly back in place hold
down the button, making sure that the rod is
completely extracted.
•
Introduce the tap into the seat and push until
the push button returns to its initial position
(Fig 28).
Cleaning the Drip Tray
The drip tray should be emptied and cleaned daily.
Note: the tray needs to be
emptied out and cleaned every
time that the red float fitted
to the grid rises, this is to stop
liquid from leaking out.
•
Lift the tray with grid and pull it outwards to
remove it from its seating (Fig 29).
•
Wash the tray and grid separately with warm,
soapy water.
•
Dry all of the components and reposition the
grid on top of the tray.
•
Fit the tray back in place and press down to
secure it to the machine.
2024/10/30 15:28
2024/10/30 15:28
Publicité
