EN
Safety Instructions
• Position on a flat, stable
surface.
• A service agent/qualified
technician should carry out
installation and any repairs if
required. Do not remove any
components on this product.
• Consult Local and National
Standards to comply with
the following:
- Health and Safety at Work
Legislation
- BS EN Codes of Practice
- Fire Precautions
- Wiring Regulations
- Building Regulations
• DO NOT immerse the
appliance in water, or use
jet/pressure washers to
clean the appliance.
• Do not use the appliance
for anything other than its
intended use.
• Always switch off and
disconnect the power supply
to the appliance when not in
use.
• Not suitable for outdoor use.
• Keep all packaging away
from children. Dispose of
the packaging in accordance
to the regulations of local
authorities.
2
CN219_ML_A5_v4_20241030.indb 2
CN219_ML_A5_v4_20241030.indb 2
• If the power cord is
damaged, it must be
replaced by a BUFFALO
agent or a recommended
qualified technician in order
to avoid a hazard.
• This appliance is not
intended for use by persons
(including children) with
reduced physical, sensory or
mental capabilities, or lack
of experience or knowledge,
unless they have been given
supervision or instruction
concerning the use of the
appliance by a person
responsible for their safety.
• BUFFALO recommend that
this appliance should be
periodically tested (at least
annually) by a Competent
Person. Testing should
include, but not be limited
to: Visual Inspection, Polarity
Test, Earth Continuity,
Insulation Continuity and
Functional Testing.
• BUFFALO recommend that
this product is connected
to a circuit protected by an
appropriate RCD (Residual
Current Device).
2024/10/30 15:28
2024/10/30 15:28