FLAEM AirMate Mode D'emploi page 21

soft, biocompatible ma-
, bends outwards
method A: Obtain a disinfectant of the electrolytic chloride type (active ingredient: sodium
hypochlorite), speci cally for disinfection, available in all pharmacies.
Execution:
- Fill a container of a suitable size to hold all the individual components to be disinfected with a
solution of drinking water and disinfectant, observing the proportions indicated on the packaging
of the disinfectant.
- Completely immerse each individual component in the solution, taking care to avoid the formation
of air bubbles in contact with the components. Leave the components immersed for the period of
time indicated on the disinfectant packaging, and associated with the concentration chosen for the
preparation of the solution.
- Recover the disinfected components and rinse them thoroughly with lukewarm drinking water.
- Dispose of the solution according to the disinfectant manufacturer's instructions.
method B: Disinfect accessories by boiling them in water for 10 minutes; use demineralised or distilled
water to avoid hard water deposits.
method C: Disinfect the accessories in a hot bottle steamer (not microwave). Carry out the process
strictly according to the hot bottle steamer's instructions. For disinfection to be e ective, choose a
steriliser with an operating cycle of at least 6 minutes.
After disinfecting the accessories, shake them vigorously and place them on a paper towel, or
alternatively dry them with a hot air jet (e.g. hair dryer).
At the end of each use, store the device complete with its accessories in a dry and dust-free place.
AIR FILTRATION
The appliance is equipped with an extraction lter (A3) to be replaced
with a replacement lter (D1) when it is dirty or changes colour. Do
not wash or re-use the same lter. Regular replacement of the lter is
necessary to help ensure proper compressor performance. The lter must
be checked on a regular basis. Contact your dealer or authorised service
centre for replacement lters.
To replace the lter, pull it out as shown in the gure.
The lter is designed so that it is always tted in its housing. Do not replace the lter during use. Only
use original Flaem accessories or spare parts, no liability is accepted if non-original parts or
accessories are used.
21