FLAEM AirMate Mode D'emploi page 20

HOW TO USE THE "RF8 DUAL SPEED" NEBULISER WITH SPEED SELECTOR
To speed up inhalation therapy, turn the speed selector (B2.2.3) clockwise.
To make the inhalation therapy more e ective, turn the speed selector (B2.2.3)
anticlockwise, in this case you will achieve optimal drug administration while
minimising the dispersion of the drug in the surroundings.
SoftTouch masks
Soft SoftTouch masks have an outer edge made of soft, biocompatible ma-
biocompatible terial that ensures an optimal t on the face, and are also equipped with
material theinnovative Dispersion Limiter. These characteristic features allow
for greater sedimentation of the drug in the patient, and again limit its
dispersion.
Dispersion
Limiter
Upon inhalation, the tab, which acts as
a Dispersion Limiter, bends inwards in
the mask.
HYGIENIC PREPARATION
Switch o the appliance before each hygienic preparation operation and disconnect it from the mains.
Compressor unit (A) and pipe exterior (B1)
Use only a cloth moistened with antibacterial detergent (non-abrasive and free of solvents of any kind).
Nebuliser and accessories
Open the nebuliser by turning the upper part (B2.2) anticlockwise, take apart the upper part (B2.2) as shown
in the "Connection diagram" in point B2.2.
Then proceed according to the instructions below.
Sanitisation
Before and after each use, sanitise the nebuliser and accessories by choosing one of the methods
provided in the table and described below.
method A: Sanitise the accessories under warm drinking water (approx. 40°C) with mild dishwashing
detergent (non-abrasive).
method B: Sanitise the accessories in the dishwasher with the hot cycle (70°C).
method C: Sanitise the accessories by soaking in a solution of 50% water and 50% white vinegar, then
rinse thoroughly with warm drinking water (approx. 40°C).
After sanitising the accessories, shake them vigorously and place them on a paper towel, or
alternatively dry them with a hot air jet (e.g. hair dryer).
Disinfection
After sanitising the nebuliser and accessories, disinfect them using one of the methods provided in the
table and described below. Each method can be performed for a limited number of times (see gure
in table).
Upon exhalation, the tab, which acts as
a Dispersion Limiter, bends outwards
from the mask.
20
metho
hypochlorite), speci cally for disinfection,
Execution:
-
-
-
-
metho
water to avoid hard water deposits.
metho
str
steriliser with an operating cycle of at leas
At the end of each use, store the device
AIR FILTRATION
The appliance is equipped with an extrac
with
not
nec
be
centre for replacement lters.
To replace the lter, pull it out as shown
The lter is designed so that it is always t
use
accessories are used.