FLAEM AirMate Mode D'emploi page 15

WARNINGS ON INTERFERENCE RISKS DURING USE IN DIAGNOSTIC IN
VESTIGATIONS
This device is designed to meet the current requirements for electromagnetic compatibility. As far as EMC
requirements are concerned, electromedical devices require special care when being installed and used,
and are therefore required to be installed and/or used in accordance with the manufacturer's speci cations.
Risk of potential electromagnetic interference with other devices. Mobile or portable RF radio and
telecommunication devices (mobile phones or wireless connections) may interfere with the operation of
electromedical devices. The device may be susceptible to electromagnetic interference in the presence of
other devices used for speci c diagnosis or treatment. For more information visit www. aemnuova.it.
t is ammable with
CASE HISTORY OF FAULTS AND THEIR RESOLUTION
Before performing any operation, switch o the appliance and disconnect it from the mains.
Problem
Thedevice is not
working
The device does not
nebulise or nebulises
poorly
The device is louder
than usual
If, after checking the conditions described above, the device still is not working properly, we recom-
mend that you contact your trusted dealer or an authorised FLAEM service centre nearest to you. You
can nd a list of all Service Centres at http://www. aemnuova.it/it/info/assistenza
Cause Remedy
Power cable not correctly
plugged into the appliance
Plug the power cable correctly into the sockets
socket or mains power
socket
The medicine was not Pour the right amount of medicine into the
inserted into the nebuliser nebuliser
Disassemble and reassemble the nebuliser
The nebuliser has not been
correctly according to the connection diagram
assembled correctly.
on the cover.
Hygienic preparation of the nebuliser. Deposits
of medicine due to lack of hygienic preparation
The nebuliser is obstructed of the nebuliser impair its e ciency and
function. Strictly follow the instructions in the
HYGIENIC PREPARATION chapter.
The accessories are not Check the correct connection between the air
properly connected to the inlet of the appliance and the accessories (see
appliance connection diagram on cover).
Unwind the pipe and check it for crushing or
The pipe is bent or damaged
punctures.
or twisted
Replace it if necessary.
The air lter is dirty Replace the lter
The lter is inserted Insert the lter properly into the housing
15