FLAEM AirMate Mode D'emploi page 19

EQUIPMENT AND MATERIAL INFORMATION
The equipment includes:
B4 - Paediatric SoftTouch mask
B5 - Adult SoftTouch mask
B -
B6 - Adult nasal piece
IMPORTANT NOTE: There is an identi cation label on the packaging, remove it and a x it in
the spaces provided on page 2. When replacing the Nebuliser and accessories, perform the
same procedure.
C -
Accessory pouch
OPERATING INSTRUCTIONS
Before each use, wash your hands thoroughly and clean your appliance as described in the
section "HYGIENE PREPARATION". During application, it is recommended to adequately protect
oneself from drips. This appliance is suitable for the administration of medicinal substances
(solutions and suspensions), for which aerosol administration is envisaged; such substances
must in any case be prescribed by a doctor. In the case of substances that are too dense, dilution
with suitable saline solution may be necessary, as prescribed by a doctor.
1. Insert the plug of the power cable (A6) into a mains
socket corresponding to the voltage of the appli-
ance. It must be positioned in such a way that dis-
connection from the power grid is not di cult.
2. Reassemble the upper part with the selector
switch as shown in the connection diagram sect.
B2.2.
Attention, the selector support (B2.2.2) must t
perfectly into the upper part (B2.2.1), to do this you
must align the arrow on the selector support with
the accessory coupling notch, see picture.
3. Add the medicine prescribed by the doctor into
the lower part (B2.1). Insert the upper part (B2.2)
into the lower part (B2.1), close the nebuliser by
turning the upper part (B2.2) clockwise.
4. Connect the accessories as shown in the 'Connection Diagram' on the
cover.
5. Sit comfortably while holding the nebuliser in your hand, place the
mouthpiece to your mouth or use a nasal piece (if provided) or mask.
If you use the mask accessory, place it on your face as shown in the
gure (with or without the use of the elastic band).
6. Switch on the device by pressing the switch (A1) and inhale and ex-
hale deeply; after inhaling, it is recommended to hold your breath for
a moment so that the inhaled aerosol droplets can settle. Then exhale
slowly.
7. When the application is nished, switch o the device and disconnect
it from the mains.
ATTENTION: If, after the therapy session, an obvious deposit of moisture forms inside the tube (B1),
detach the tube from the nebuliser and dry it with the ventilation of the compressor itself; this action
prevents possible mould growth inside the tube.
To facilitate the connection of the connection tube (B1) to the compressor unit, act on the end of it by
simultaneously rotating and inserting it, and for removal by rotating and extracting it.
Information on materials
Polypropylene +
Thermoplastic Elastomers
Polypropylene
B2.2.1
19
B2.2.2