Connecting The Device To The Megaview20 Modulator - Marmitek MEGAVIEW20 Guide Utilisateur

1x MegaView20 modulator
1x Power adapter
1x IEC Antenna cable (1 metre)
1x Manual
3. CONNECTING THE DEVICE TO THE MEGAVIEW20
MODULATOR
Switch off all devices before you start connecting. Then connect the device
you want to connect (for instance the DVD-player or AV-camera) to the
MegaView20. You can connect the device with a SCART cable or a cinch
cable. Use one of the two possibilities mentioned below.
Connecting an A/V appliance via SCART (1)
You can use the 'SCART connection' on the modulator to add the video-
and audio signal desired to the antenna signal. You can use a SCART cable
(not included) and you connect this to the 'SCART IN' of the MegaView20.
Tip: See chapter 6 Extra options for the possibility to connect
multiple devices
Connecting an A/V appliance via cinch cable (2)
Any so called composite audio- and video signal can be connected to the
modulator. For this you can use a cinch cable (not included). Make sure the
colours of the plugs and the sockets are corresponding. That means red to
red, white to white and yellow to yellow.
MEGAVIEW20
1
2
SCART IN
ANT/RF IN ToTV/RF OUT
5