Connecting The Antenna Signal To The Megaview20 Modulator - Marmitek MEGAVIEW20 Guide Utilisateur

A/V appliance via SCART to TV (3)
The 'SCART OUT' connection on your MegaView20 offers you the
possibility to connect not only the signal of your A/V devices to the antenna
signal, but to also loop it to a TV set via SCART (for instance for TV sets
that are not connected to your antenna network).
SCART OUT
Attention: This connection only transfers the A/V signal of the
connected device back to the TV set and not the other TV
channels.
4. CONNECTING THE ANTENNA SIGNAL TO THE
MEGAVIEW20 MODULATOR
Follow the description below to connect the antenna cable.
Connecting an antenna cable (4)
Connect the existing antenna cable to the 'ANT/RF IN' connector of the
MegaView20. Depending on the current situation you may need to
disconnect some of the cables before you can connect the antenna.
Connecting an antenna cable to TV (5)
Connect the 'To TV/ RF OUT' of the MegaView20 to the antenna port of
the television set (if necessary with the use of included antenna cable).
If you want to watch this signal at multiple places, you connect a splitter
between the MegaView20 and the TV (your supplier of antenna materials
can advice you in this). On every television connected to the antenna
6
4
ANT/RF IN
3
5
ToTV/RF OUT
© MARMITEK