Set Contents; Connecting Appliances To The Megavideo55 Modulator - Marmitek MEGAVIDEO55 Mode D'emploi

added to the outgoing aerial signal. The added audio/video signal can now be viewed on the
channel that has been set on any televisions that are connected after the modulator (on the
'RF ANT OUT' side of your MegaVideo55). You do not need to change any other part of your
aerial network.
Thanks to the built-in "infrared return channel" you can continue to operate the connected
appliances from other rooms using your own remote control. One infrared receiver is supplied
as standard. Additional receivers can be purchased should you wish to operate your
equipment from different rooms.
The infrared return channel only works with amplifiers, splitters and aerial wall outlets that
are return channel compatible. Compatible components are usually marked '5 – 30 MHz' or
'5 – 68 MHz'. Your aerial specialist can provide more information on this.
The modulator itself has no effect on the signal strength. The maximum length of cable that
can be used depends on the cable network in your house. If you want to connect a number
of TVs or use longer cable lengths it is recommended that you use an amplifying splitter. Your
aerial equipment supplier can give you advice on this.

2. SET CONTENTS

1x Stereo modulator
1x Infrared receiver
2x Power adapter
1x RCA-RCA cable
2x Adapter F-connector to IEC-connector male
2x Adapter F-connector to IEC-connector female
1x Scart doubler
1x IR extender cable with 1 LED
1x User manual
3. CONNECTING APPLIANCES TO THE
MEGAVIDEO55 MODULATOR
Turn off all appliances before making any connections. Now attach the appliance you want to
connect (e.g. the DVD player) to the MegaVideo55. There are a number of ways to do this.
Using an RCA cable
All types of composite video signal and audio signal can be connected to the modulator. This
can be done using the supplied RCA cable. Ensure that the plug and socket colours match
each other. That is, red to red, white to white and yellow to yellow.
Using a scart cable
If the appliance you want to connect has a 'scart connection' you can use the supplied scart
doubler. When this is used you do not loose the use of the scart connection, so it can still be
4 © MARMITEK