Frequently Asked Questions - Marmitek SPEAKER ANYWHERE 200 Guide Utilisateur

Switching OFF
1. Turn the VOLUME ON/OFF button until the click sound is heard to turn off the speaker and
the LED light goes off.
2. For protection of the transmitter and power saving, the transmitter will shut down
automatically if there is no/weak input signal from audio source for 4 minutes.
3. If the signal comes back, the transmitter will work again automatically.

FREQUENTLY ASKED QUESTIONS

No Sound
Ensure;
* the speaker is switched ON.
* the audio source is switched ON and playing.
* the volume of the audio source and speakers is high enough.
* the power adapter is fully inserted into the wall outlet and the Power connection (DC IN)
on the transmitter and speaker.
* the battery capacity is sufficient. Replace with new batteries or connect a power adapter
to the speakers.
Distorted sound
* Press the "AUTO TUNING" button on the speakers to tune the right frequency.
* Select an other channel (1 or 2) on the transmitter and press on the "AUTO TUNING"
button on the speakers.
* Check the battery capacity. Replace with new batteries or connect a power adapter to the
speakers.
* The speaker is too far from the transmitter, move closer.
* Input level of the audio source is too high or too low. Adjust the volume of the audio
source until the sound is received correct.
SPEAKER ANYWHERE 200™
7