Marmitek SPEAKER ANYWHERE 200 Guide Utilisateur page 4

INSTALLATION
Transmitter
3
1. Antenna
2. Power indication LED (Red)
3. Signal indication LED (Green)
4. Channel switch
5. Power connection (DC IN)
1. Put the antenna tube over the antenna wire.
2. Plug the supplied AC power adapter in the Power connection (DC IN), located on the rear
of the transmitter.
3. The back of the transmitter has an audio cord that can be connected to audio output
(normally indicated with
player. To connect the transmitter to an audio source without 3.5mm jack Audio out, you
can use the supplied 6.3mm jack or RCA adapter.
Plug the power adapter in the electrical wall outlet and the Power LED (
soon as the transmitter is receiving the audio signal, it will automatically switch on and the
Signal LED ( ) will illuminate.
4
1
2
4
or AUDIO OUT) of i.e. TV, PC, Radio, CD-/MP3-/MP4-/DVD
5
) will light up. As
© MARMITEK