HQ Power VDPL300MF6 Notice D'emploi page 5

• Auto Mode
1
2
3
4
5
• Sound-Active Mode
1
2
3
• Master/Slave Mode
1 Master
2 Slave
7. DMX512 Mode
When operating the VDPL300MF6 through a DMX controller, you can create your own programs
and tailor them to your own needs. Each individual fixture is controllable through a standard DMX
controller. To run your projector in DMX mode, connect a controller using a standard DMX cable.
Press MODE until D.XXX is displayed. Set the DMX address.
• Detailed DMX Values per Channel
Channel
1
2
3 ~ 9
10
• DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side
to the male 3-pin XLR input of the VDPL300MF6. Multiple VDPL300MF6s can be linked through
serial linking. The linking cable should be a two-core screened cable with XLR input and output
connectors.
• DMX512 Chain with Termination
VDPL300MF6
Flash
Automatic fade in and fade out
Automatic 7-colour change
Chase lights
Chase lights speed
Sound chase lights
Sound 7-colour flash
Se00~Se15
Choose mode (stand-alone, auto, sound-active)
Function From
LED control
Speed
Single gobo
Single gobo
Sound control
A DMX terminator is recommended for installations where the DMX cable has
to run a long distance or is in an electrically noisy environment (e.g. discos).
The terminator prevents corruption of the digital control signal by electrical
noise. The DMX terminator is simply an XLR plug with a 120Ω resistor
between pins 2 and 3, which is then plugged into the XLR output socket of
the last device in the chain. Please see illustrations.
To Description
0 9 LED off
10 199 Macro 1 ~ macro 38
200 239 Flash 1 ~ 11Hz
240 255 LED on
0 255 Slow to fast macro/flash
0 63 Static gobo
64 255 Gobo chase
0 255 Static gobo
0 127 Control channel 1 ~ 9
128 255 Sound control
5 HQPOWER™