Télécharger Imprimer la page

Ryobi RYRM8001CAN Manuel D'utilisation page 30

Masquer les pouces Voir aussi pour RYRM8001CAN:

Publicité

STORING THE MOWER
The following steps should be taken before storing the mower
for the season.
„ Remove any build-up of grass and leaves on or around the
motor cover. Wipe the mower clean with a dry cloth. Do
not spray with a garden hose, water, or liquids to clean.
„ Plug the mower up to charge for the entire time of storage.
„ NOTE: If it is not possible to leave the mower charger
connected during storage, charge the batteries at least
once a month during storage.
„ Store mower in a clean, dry place that is inaccessible to
children. Do not store near any appliance that operates
with flame such as a gas water heater, clothes dryer, or
furnace.
„ NOTE: Set the parking brake and do not leave the key
in the mower during storage. Place the key in a location
that is inaccessible to children.
MAINTENANCE SCHEDULE
Check Brake Operation
Check Tire Pressure
Check Safety Interlock System
Check for Loose Fasteners
Clean Debris From Mower
Check/Replace Mower Blades
Clean Battery Terminals
NOTE: Maintenance should be performed more frequently when mower is used in dusty areas.
When mower has exceeded the maximum figures specified in the table, maintenance should still be cycled according
the intervals of time or hours stated herein.
If you are unsure how to perform any of the maintenance items listed above, take the mower to an authorized service center for
assistance.
MAINTENANCE
Inspect
Every
Before
25
Each Use
Hours
X
X
X
X
X
X
30 — English
„ If the mower must be stored outside, make sure it is cov-
ered completely to protect it from the elements.
„ Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
PREPARING FOR USE AFTER STORAGE
The following steps should be taken before using the mower
after it has been stored:
„ Review maintenance chart.
„ Fully charge the batteries.
„ Check tire pressure and inflate as needed.
„ Briefly drive the mower and check all systems and com-
ponents to ensure they are functioning correctly.
„ Periodically inspect for frayed and deteriorated insulation
on wires.
Every
50 Hours
or Yearly
X
X
X
Every
Before
100
Storage
Hours
X
X
to

Publicité

loading

Ce manuel est également adapté pour:

Ryrm8001