Télécharger Imprimer la page

Ryobi RYRM8001CAN Manuel D'utilisation page 29

Masquer les pouces Voir aussi pour RYRM8001CAN:

Publicité

„ Disconnect the battery pack's quick-connect plug by
squeezing the tabs, releasing it from the battery pack,
and moving it aside. This plug connects/disconnects the
batteries from the mower.
„ Release the battery latch that secures the battery pack
by turning it counterclockwise.
„ Raise the battery pack from the battery port.
„ Replace the battery pack or packs as needed by lowering
it into the battery port.
„ Secure the battery pack by turning the battery latch
clockwise.
„ Reinstall the battery pack's quick-connect plug.
„ Repeat the steps for additional battery packs if necessary.
„ Lower the lid to the battery compartment and press on
the center edge to engage the lock.
NOTE: Make sure the battery compartment cover is se-
curely locked before readjusting the seat. Check to be
sure the safety interlock cable is still connected.
„ Readjust the seat to a comfortable position before driv-
ing the mower.
When removing/replacing a 40 volt battery pack:
There are two additional 40 volt battery ports that can help
extend the run time of the zero turn lawnmower. However,
these additional batteries are not required to operate the
zero turn mower.
NOTE: The zero turn mower will not operate on only 40 volt
batteries. The unit must have at least one operable 80 volt
battery to run the drive and blade motors.
„ Open the battery ports located on each side of the mower.
„ While depressing the battery latch, grasp the handle and
raise the battery from the port.
„ To install, align the raised ribs on the battery pack with
grooves in the battery port and install the battery pack
into the mower.
„ Make sure the latch is securely locked into place.
„ Repeat the steps for additional batteries if necessary.
WARNING:
Make sure the latch on the bottom of the battery packs
snaps in place and the battery pack is fully seated and
secure in the mower's battery port before beginning
operation. Failure to securely seat the battery packs could
cause the battery packs to fall out, resulting in serious
personal injury.
For complete charging instructions, refer to the Operator's
Manuals for your battery packs and charger models.
MAINTENANCE
80V
BATTERY
BATTERY
40V BATTERY
29 — English
80V
PORT
LATCH
PORT
BATTERY
LATCH
Fig. 29
BATTERY
COVER
BATTERY
Fig. 30

Publicité

loading

Ce manuel est également adapté pour:

Ryrm8001