Publicité
ORIGINAL INSTRUCTIONS
EN
Safety, performance, and dependability have been given top
priority in the design of your stapler.
INTENDED USE
The stapler is intended to be used only by adults who
have read and understood the instructions and warnings
in this manual, and can be considered responsible for
their actions.
The stapler is intended to drive staples in soft materials such
as wood. The product can be used for:
■
driving staples into wood
■
with the included accessory, driving staples to secure
fencing wire and wire screen
■
driving staples for upholstery (fabrics)
■
driving staples into plastics
■
driving staples into paper and cardboard
■
driving staples to secure carpet underlays
Do not use the product in any way other than those stated
for intended use.
NOTE: Some timbers (such as very dry hardwood) may
require shorter staples to fully drive in. For best performance,
use the product on white pine.
WARNING! Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool'' in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
STAPLER SAFETY WARNINGS
■
Always assume that the product contains fasteners.
Careless handling of the stapler can result in unexpected
firing of fasteners and personal injury.
■
Do not point the product towards yourself or anyone
nearby. Unexpected triggering will discharge the
fastener causing an injury.
■
Do not actuate the product unless the product is
placed firmly against the workpiece. If the tool is
not in contact with the workpiece, the fastener may be
deflected away from your target.
■
Disconnect the product from the power source when
the fastener jams in the product. While removing a
jammed fastener, the stapler may be accidentally
activated if it is plugged in.
■
Use caution while removing a jammed fastener. The
mechanism may be under compression and the fastener
may be forcefully discharged while attempting to free a
jammed condition.
Do not use this stapler for fastening electrical cables.
■
It is not designed for electric cable installation and may
damage the insulation of electric cables thereby causing
electric shock or fire hazards.
ADDITIONAL SAFETY WARNINGS
■
The product is designed for single-hand use. Do not
hold the product by the front of the magazine. Do not put
hands, head, or other parts of your body near the bottom
of the magazine where the fastener exits the product, as
serious personal injury could be caused.
■
Always ensure that the workpiece contact is fully
positioned above the workpiece. Positioning the
workpiece contact only partially above the workpiece
could cause the fastener to miss the workpiece
completely and result in serious personal injury.
■
Do not drive fasteners near edge of material. The
workpiece may split causing the fastener to ricochet,
injuring you or a coworker. Be aware that the fastener
may follow the grain of the wood, causing it to protrude
unexpectedly from the side of the work material or
deflect, possibly causing injury.
■
Keep hands and body parts clear of immediate work
area. Hold workpiece with clamps when necessary to
keep hands and body out of potential harm. Be sure
the workpiece is properly secured before pressing the
fastener against the material. The workpiece contact
may cause the work material to shift unexpectedly.
■
Keep face and body parts away from back of the tool
cap when working in restricted areas. Sudden recoil can
result in impact to the body, especially when stapling into
hard or dense material.
■
During normal use the product will recoil immediately
after driving a fastener. This is a normal function of
the product. Do not attempt to prevent the recoil by
holding the product against the work. Restriction
to the recoil can result in a second fastener being
driven from the product. Grip the handle firmly, let the
product do the work and do not place second hand on
top of the product or near exhaust at any time. Failure
to heed this warning can result in serious personal
injury.
■
Do not drive fasteners on top of other fasteners or
with the product at an overly steep angle as this may
cause deflection of fasteners which could cause
injury.
■
Always check the work area for hidden wiring, gas lines,
water lines, etc., before using the product on such work
area.
■
Only fasteners matching the description in the product
specifications table can be used with the product.
Using incorrect fasteners may lead to jamming or other
malfunctions.
■
Clamp workpiece with a clamping device. Unclamped
workpieces can cause severe injury and damage.
■
The product will restart automatically if stalled. Switch
off the product immediately if it stalls. Do not switch
on the product again while it is still stalled, as doing so
could trigger a sudden recoil with a high reactive force.
Determine why the product stalled and rectify this,
paying heed to the safety instructions.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
3
Publicité
