Publicité
DEFROSTING
Defrosting must be carried out when the ice layer is thicker than 4 mm.
Set the thermostat at the OFF position. While defrosting, keep food and beverages in a cool place.
Do not use any sharp metal object to remove the ice or frost. Do not start the refrigerator up again until it is completely
defrosted and dry. Also empty the main tray.
CLEANING
Periodically clean the inside of the refrigerator using sodium carbonate dissolved in lukewarm water.
Avoid using abrasive products, cleaners or soaps. After cleaning, rinse with fresh water and dry with care. When you are not
using the refrigerator, clean and dry its inside to prevent mould and bad smells formation.
Do not wash the refrigerator drawers and parts in a dishwasher.
MAINTENANCE
Before every maintenance operation, disconnect the power supply from the main connector.
Since the evaporator operates at temperatures well below freezing, ice and frost will inevitably form upon it.
The humidity in the air, the temperature and the number of times the door is opened will have a significant impact on frost
formation.
The refrigerator should always be defrosted when the layer of frost on the evaporator reaches a thickness of 3-4 mm or
more.
Turn off the refrigerator by turning the thermostat to its 0 position.
Defrosting should be performed when the products can remain as cool as possible outside of the refrigerator itself. Do not
use sharp objects to remove ice and frost from the evaporator, as this could damage it and result in leaks.
Only turn the refrigerator back on once it has been defrosted, cleaned and thoroughly dried. Remove, empty and dry the
drip tray beneath the evaporator. A towel can be placed at the base of the refrigerator during the defrosting procedure in
order to facilitate water collection.
USEFUL ADVICES
If the refrigerator does not work, or if it works wrongly, before referring to our after sales service, make sure that:
- power is not missing,
- the voltage which reaches the main connector is equal to the one shown on the label,
- the connections are correctly made,
- the ventilation grids are not obstructed,
- the refrigerating unit is not near a source of heat,
- the fuse mounted on the power line is not blown.
The power cable must be replaced only by qualified technical personnel and, in any case, by a service authorized
by the manufacturer.
Indel B OFF disclaims any responsibility if the above instructions and conditions are not followed or not met.
27
OFF IS A BRAND OF INDELB
EN
Publicité
