IP1022_38Q00CP_06_070403
Care and Cleaning of Your Microwave Oven
Cleaning Vent Grille (Oven Air Vent)
1. Moisten a soft cloth in hot water containing mild detergent.
2. Wipe the front surface gently.
3. Tilt the Grille cover forward slowly as shown in Fig. A.
4. Wipe inside the Grille cover.
To avoid the risk of injury when cleaning, DO NOT directly
contact the metal edges of the Grille cover.
Installing the replacement Charcoal Filter
(NN-CF203)
This product is shipped for use in the top exhaust ventilation
mode. If you wish to install this product without using an
exhaust duct, the exhaust must be recirculated through the
front louver and a charcoal filter. A charcoal filter has been
installed for your convenience. However, we recommend that
this filter be changed as soon as possible with the replacement
charcoal filter kit (NN-CF203) that can be purchased from your
local Panasonic dealer. The charcoal filter cannot be cleaned.
Once the replacement filter has been installed, it should be
replaced periodically every 6 to 12 months, or more often if
necessary. Refer to the following instructions for replacement.
1. Remove the Vent Grille
Pull the front louver down to open as shown in Fig. B.
Remove two screws from the front and one from the top,
then pull the Vent Grille forward.
Screws
2. Remove the Standard Charcoal Filter
Insert your finger under the bottom of the filter, and pull the
Charcoal Filter forward as shown in Fig.C.
All manuals and user guides at all-guides.com
2007.4.3
11:02
Page 28
(Fig. A)
(Fig. B)
(Fig. C)
3. Install replacement Charcoal Filter (NN-CF203)
Install the Charcoal Filter aligning the two holes, then secure
with two screws as shown in Fig. D.
Screw
(Fig. D)
Installing Vent Grille
1. Slide the top flange of Grille along the top plate, then tilt the
Grille down to fit as shown in Fig. E.
Top flange of Grille
(Fig. E)
2. Tilt the front louver downwards, then secure with three
screws, one on each side and one on top as shown in
Fig. F.
Screws
(Fig. F)
26
(continued)
Screw
Top Plate