EINHELL GP-LS 18/28 Li T BL Instructions D'origine page 22

10. Troubleshooting guide
Danger!
Before troubleshooting, switch off the tool and remove the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if
your tool fails to work properly. If you fail to localize and solve the problem after working through the list,
please contact your nearest service workshop.
Fault
The tool does not
work
The tool stops du-
ring cutting
The cut is not
smooth
Anl_GP_LS_18_Li_T_BL_SPK13.indb 22 Anl_GP_LS_18_Li_T_BL_SPK13.indb 22
GB
Possible cause
- The battery is empty
- The tool/battery is not correctly in-
serted
- The battery is empty
- The battery capacity is low
- The wood is too hard
- The wood diameter is too large
- The cutting blade is blunt or worn
- 22 -
Remedy
- Charge the battery
- Remove the battery and insert again
- Charge the battery
- Charge the battery
- The wood is unsuitable for cutting
- The wood is unsuitable for cutting
- Replace the cutting blade
23.07.2024 08:36:23 23.07.2024 08:36:23