Publicité
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before using for the fi rst time
Warning!
Always remove the battery before making adjust-
ments to the tool.
5.1 Fitting the guard handle (Fig. 3)
The guard handle (Item 24) must be fastened with
the assembly screws (Item 23) to both sides of
the housing.
5.2 Removing the blade guard hood (Fig. 4)
Remove the blade guard hood by unfolding it.
5.3 Fitting the battery (Fig. 5-6)
Fig. 5 shows the fi tting of the battery when the
tool is used without the telescopic, and Fig. 6
shows it when used with the telescopic tube.
Press the pushlock button (A) of the rechargeable
battery and press the rechargeable battery into
the mount provided. Make sure that the pushlock
button latches in place. To remove the battery,
proceed in reverse order!
5.4 Charging the Li battery pack (Fig. 5-7)
1. Remove the battery pack from the handle,
pressing the pushlock button (A) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate. Insert the po-
wer plug of the charger into the socket outlet.
The green LED will then begin to fl ash.
3. Push the battery pack onto the battery char-
ger.
4. In the section entitled „Charger indicator" you
will fi nd a table with an explanation of the LED
indicator on the charger.
Anl_GP_LS_18_Li_T_BL_SPK13.indb 18
Anl_GP_LS_18_Li_T_BL_SPK13.indb 18
GB
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.5 Battery capacity indicator (Fig. 8)
Press the button for the battery capacity indicator
(B). The battery capacity indicator (C) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
- 18 -
23.07.2024 08:36:22
23.07.2024 08:36:22
Publicité
