Publicité
Model(s): 2400 • 2404
IGNITIoN INsTRUCTIoNs
1. CHECK VALVES
ensure gas is oFF before checking appliance valves�
Turn all knobs to the ❶ ❶ oFF position�
STEP 01
Push in knob and release� Knob should spring back�
STEP 02
If knobs do NoT
If knobs
do NoT spring back, replace valve assembly before using appliance.
spring back, replace valve assembly before using appliance.
Rotate knob to loW then turn back to oFF� Knob should
STEP 03
turn smoothly�
Connect and turn oN the gas, as applicable�
STEP 04
(Please reference the gas connection section.)
(Please reference the gas connection section.)
2. THERMOCOUPLE SURE-START IGNITION
Note: Keep the oven door closed as much as possible to reach and
maintain temperature�
ensure there is one (1)
STEP 01
AA battery under the battery cap�
STEP 02
❶ ❶ Turn the Pizza oven control knob to oFF�
❷ ❷ Turn on the motor�
❸ ❸ Push in the control knob and turn counterclockwise a quarter
turn to loW� Hold in for 10~20 seconds until thermocouple heats
up� You should hear the igniter clicking the entire time� (When you
release the knob, the oven should remain lit�)
once the flame is consistent, adjust to desired
STEP 03
temperature ❹.
❹.
❶ ❶
❸
❸
❹ ❹
Before first use, run the oven for 15-20 minutes on HIGH to burn off manufac-
Before first use, run the oven for 15-20 minutes on HIGH to burn off manufac-
turing remnants.
turing remnants.
BLACKSTONEPRODUCTS.COM
Clean the battery and appliance
Clean the battery and appliance
contacts prior to battery installation.
contacts prior to battery installation.
❷ ❷
OPERATION INSTRUCTIONS
3. ALwAYS CHECK BURNER FLAME BEFORE USE.
2. THERMOCOUPLE SURE-START IGNITION
light burners and look below the cooking surface to view burners�
Remove the oven door� do NoT use the oven door at any time
When knob is at HIGH, flames should be larger than when knob
while the oven is in use�
is at loW�
Insert one (1) AA battery
STEP 01
under the battery cap�
HEALTHY FLAME PATTERN
screw the cap into place over the
positive terminal�
❶ ❶ Turn the Pizza oven control knob to oFF� ❷ ❷ Turn on the
STEP 02
Flickers of yellow.
Flickers of yellow.
motor� ❸ ❸ Push in the control knob and turn counterclockwise a
dark blue.
dark blue.
quarter turn to loW� Hold in for 10~20 seconds until thermocouple
Vibrant blue.
Vibrant blue.
heats up� You should hear the igniter clicking the entire time� (When
you release the knob, the oven should remain lit�) once the flame is
consistent, adjust to desired temperature ❹.
If burner does not ignite with open gas supply valve, gas
❶ ❶
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
If ignition does not occur in 5 seconds:
1. Turn the burner control knob OFF.
❸ ❸
2. Wait 5 minutes.
3. Repeat the lighting procedure.
If burner does not ignite, please reference the Troubleshooting chapter.
If burner does not ignite, please reference the Troubleshooting chapter.
❹ ❹
Before first use, run the oven for 15-20 minutes on HIGH to burn off manufac-
Before first use, run the oven for 15-20 minutes on HIGH to burn off manufac-
turing remnants.
turing remnants.
| OWNER'S MANUAL
YELLOw OR IRREGULAR
Clean the battery and appliance
Clean the battery and appliance
contacts prior to battery installation.
contacts prior to battery installation.
If flames are yellow or irregular,
If flames are yellow or irregular,
please reference the Troubleshooting
please reference the Troubleshooting
chapter.
chapter.
WARNING
❹.
❷ ❷
3. A
ligh
is at
HEA
F F
d d
V V
If b
wi
in
If
1. T
2. W
3. R
If bu
If bu
09
Publicité
