Publicité
FR
ES
2. ASSEMBLY THE MITER LOCK
1. Take out the dual-purpose hex wrench from the machine first.
PT
2. Use the hex wrench to remove the screw.
3. Insert the miter lock handle into the clamping block.
IT
4. Use the hex wrench to tighten the screw.
3. TRANSPORTATION
EL
Lift the miter saw only when the saw arm is locked in the down position, the saw is switched off
and the plug is removed from the power supply.
PL
Only lift the saw by the handle or outer castings. Do not lift the saw using the guards.
4. BENCH MOUNTING
UA
To ensure that the miter saw is always stable and secure.Before use,the saw can be fixed to a firm,
level surface with the 4 mounting bolts (Not supplied).Four holes are provided in the base of the
RO
saw to enable it to be fixed to a bench, or other supporting surface.
1. Place the saw on a level, horizontal bench or work table using bolts (not supplied) and fix the
EN
saw to the bench using 4 bolts.
2. If desired, you can mount the saw to a piece of 1/2" (13 mm) or thicker plywood which can then
be clamped to your work support or moved to other job sites and re-clamped.
To mount the saw,proceed as follows:
1) Locate and mark where the saw is to be mounted.
2) Drill 4 holes through the surface.
3) Place the miter saw on the surface aligning holesin base with holes drilled in the surface. Install
bolts,washers and hex nuts.
CAUTION! Make sure that the mounting surface is not warped as an uneven surface can cause
binding and inaccurate sawing.
5. RELEASE KNOB
The Release knob (21) is provided for holding the cutting head down while transporting or storing
the miter saw. The saw must never be used with the release knob locking the head down.
6. MITER TABLE LOCKS
The miter lock handle (11) and miter latch button (12) are used to lock the table at the desired
miter angle.
The miter saw cuts from 0° to 45° both left and right. To adjust the miter angle loosen the miter
table locks and rotate the miter table to the desired position.The miter table features positive click
stops at 0°, 15°, 22.5°, 30° and 45° for quick setting of common miter angles.
222
222
Publicité
