Worx D-Tail WX647 Notice Originale page 12

Sanding paper
dedicated for
painting removing
Finger sanding sheet
Finger pad
Dust collection adapter
Dust collection box
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
12
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.The sander is not to be
used for plastering.
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
* Fitting the Sanding Paper
Using The Dust Adapter
3pc 6pc 6pc
3pc 6pc 6pc
1pc 1pc 1pc
1pc / /
/ 1pc 1pc
FIGURE
See Fig. A
See Fig. B1, B2
Attaching the Dust Box
CAUTION: To prevent the
possibility of sanding dust or
foreign body being thrown into your
face or eyes, never attempt to use
your sander without the dust box
properly installed.
Emptying the Dust Box
-For more efficient operation, empty
dusts box every 5-10mins.
OPERATION
On/Off Switch
Flush Sanding Facility
* Installing The Finger Pad
* Removing The Finger Pad
* Attach Sanding Sheets And Pads
Sanding With Finger Pad
* WARNING: Failure to unplug the sander could
result in accidental starting causing possible
serious personal injury.
WORK HINTS FOR YOUR PALM SANDER
If your power tool becomes too hot, run no load for 2-3
minutes to cool the motor.
Always ensure the work-piece is firmly held or clamped to
See Fig. C
See Fig. D1,
D2, D3
See Fig. E
See Fig. F
See Fig. G1, G2
See Fig. H1, H2
See Fig. I
See Fig. J