Publicité
– Set the cutting height to the value you
require, and let the lever slot back into
place.
– Loosen nut (7) and remove front wheel.
– Reinstall the front wheel at the desired
cutting height.
– The marking of the selected axle
bore (26) must match the set cutting
height on the rear wheel.
Attach the collection box
► P. 6, item 10
– Lift the protective flap (4) and hold.
– Hook in the collection box (9).
– Make that the collection box is securely
engaged.
Adjusting the front wheel
► P. 6, item 11
– Pull out the locking button (6) and rotate it
to the desired position:
• Position [ ]: rigid front wheel for mow-
ing in straight lines;
• Position [ ]: steerable front wheel for
mowing in curved lines.
Turning on the tool
Note: The product cannot be
switched on without the circuit
breaker.
► P. 6, item 12
– Insert the circuit breaker (28) (pay atten-
tion to the fit)
► P. 6, item 11
► P. 3, item 1
– Press and hold down the switch lock (10).
– Pull the switch-on lever (1) and hold.
– Release the switch lock.
• The unit will switch itself on with approxi-
mately 2 seconds delay.
Switching-off the device
– Release the switch-on lever.
– Pull out thecircuit breaker.
Mowing
WARNING! Risk of injury! Before
starting work, check the area and
remove all objects which may be
kicked up by the unit.
– Guide the unit at an even, slow pace
(walking speed) and with as straight a
path as possible.
Important notes
• Always work at right angles to the slope.
• Try not to cut grass when wet.
• Use overlapping paths to produce an
even cutting pattern.
• Cut longer grass with a greater cutting
height initially, then cut crosswise using
the desired cutting height.
► P. 6, item 10
• With the air flap (27) closed, check
whether the collecting sack is full and
empty it if necessary.
Cleaning and maintenance
DANGER! Risk of injury! Carry out
the maintenance work described here
in person.
Improper maintenance work can
damage the device and lead to inju-
ries.
DANGER! Risk of injury! Before
carrying out any maintenance or
cleaning work, the machine must be
disconnected from the power and
secured to prevent accidental switch
on.
Cleaning and maintenance overview
Before each use
What?
General function
check.
Check all screw con-
nections and tighten
if necessary.
Cleaning the device
Clean unit immediately after every use. Dried
grass remains are very hard, and are very dif-
ficult to remove.
– Remove grass remains with a brush, and
a plastic scraper if required (do not use
sharp implements).
– Remove deposits on the wheels.
– Wipe the tool with a damp cloth.
– Never clean the unit with water or high-
pressure jet.
GB
How?
Visual check.
Hand-tighten the
screw connections us-
ing the appropriate
tool.
41
Publicité
