Publicité
Fine Adjust (Fig. A)
The fine adjustment knob
for lining up the vertical beam. Place the laser level on a flat
surface and turn the knob to the right (clockwise) to rotate
the laser level to the left, or to the left (counterclockwise) to
move the beam to the right.
Using the Pivot Bracket (Fig. A, H, I)
The laser level has a magnetic pivot bracket
attached to the unit.
WARNING: Position the laser level and/or wall mount
on a stable surface. Serious personal injury or damage
to the laser level may result if the laser level falls.
•
The bracket has a keyhole slot
a nail or screw on any kind of surface.
•
The bracket has magnets
be mounted to most upright surfaces made of steel or
iron. Common examples of suitable surfaces include
steel framing studs, steel door frames, and structural
steel beams.
Multi‑Surface Mounting Plate (Fig. J)
1. To attach the laser level to a wooden stud
multi‑surface mounting plate
level using the laser's magnets
2. To attach the laser level to a metal stud
the metal stud between the multi‑surface mounting
plate
19
and the laser's magnets
multi‑surface mounting plate behind the metal stud will
significantly increase the magnetic strength and holding
capacity of the laser level.
MAINTENANCE
Your laser level has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn laser level off before making any
12
on the side of the laser level is
5
permanently
1
so it can be hung from
16
which allow the unit to
17
, screw in
19
first and mount laser
16
.
18
, sandwich
16
. Placing the
adjustments or removing/installing attachments
or accessories. An accidental start‑up can
cause injury.
•
To maintain the accuracy of your work, check the laser
level often to make sure it is properly calibrated. See
Field Calibration Check.
•
Calibration checks and other maintenance repairs may
be performed by D
WALT service centers.
e
•
Do not store your laser level in the case if the laser level
is wet. The laser level should be dried first with a soft dry
cloth prior to storage.
•
Do not use in rain.
Cleaning
WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
laser level. These chemicals may weaken the materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside
the laser level; never immerse any part of the laser level
into a liquid.
Exterior plastic parts may be cleaned with a damp cloth.
Although these parts are solvent resistant, NEVER use
solvents. Use a soft, dry cloth to remove moisture from the
laser level before storage.
TROUBLESHOOTING
The Laser Level Does Not Turn On (Fig. A)
•
Fully charge the battery.
•
If the laser level is exposed to extremely hot/cold
temperatures, the battery meter
and Cold Condition. If the laser level has been stored in
extremely hot temperatures, allow it to cool. The laser
level will not be damaged by pressing the on/off button
before cooling to its proper operating temperature.
English
7
will flash. Refer to Hot
11
Publicité
