Publicité
F – Installing the smoke duct
EN
Attach the external duct to the body of the extractor hood using 2x Ø3.5 x 9.5 mm screws,
as shown in Figure 9. Attach the internal duct to the internal duct connection panel using
2x Ø3.5 x 9.5 mm screws, as shown in Figure 10.
1. External duct
2. Ø3.5 x 9.5 mm Screws x 4
3. Chimney stack connection plug x 1
4. Internal duct
G – Installing the handle* (Optional)
To install the handle, firstly remove the filters, as shown in Figure 11.
After having aligned the handle with the installation holes, as shown in Figure 12, fasten the
handle's screw from the interior of the extractor hood.
1
2
Figure 9
Figure 11
Figure 10
Figure 12
14
3
4
Publicité
