Publicité
B – Assembly of the body of the extractor hood
Warning:
Failing to install the screws or fastenings in compliance with these instructions
may entail electrical risks.
Drill into your wall, as shown on the plan below, at points A and B. Use screws/dowels (not included)
that are adapted to your wall. Install the appliance's housing from points A, and the internal duct
connection plug at the B points.
Note: The dimensions indicated above are determined considering that the distance between the
lower point of contact of the cooking pot and the bottom of the extractor hood is 650 mm.
8
9
7
5
A
6
11
B
12
EN
Publicité
