Publicité
Adjustment
Armlift height
Make an adjustment according to your
cartridge if necessary.
Preparation
Put a record on the turntable.
Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.
Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to
step 2 .
The armlift height is factory-adjusted to
5
8 to 13 mm (
/
8
13 mm
to
(
5
/
to
33
/
" )
16
64
2
Return the tone arm to the arm
rest, clamp it with the arm clamp
and while pressing the armlift
down with your finger, turn the
screw to adjust the height.
Turning the screw clockwise lowers the
armlift.
Turning the screw anti-clockwise raises
the armlift.
Armlift
18
(18)
English
(continued)
33
to
/
").
16
64
Armlift screw
Arm clamp
Adjusting the turntable startup
speed (torque gain)
Confirmation lamp
Torque button ([1] - [3])
L (Low) ... Reduce the torque(-1)
H (High) .. Increase the torque(+1)
Press the center of the button lightly.
You can select from three options for the turntable
startup speed (time to reach constant speed after
[START-STOP] is pressed) and the torque gain at
constant speed. (The factory setting is [3]: highest.)
The confirmation lamp
blinks the specified number
of times according to the
current setting when you
press the H or L torque button.
To change the setting,
press the H or L torque button
while the lamp is lit for two
seconds.
After you press the torque button, the
confirmation lamp blinks the specified
number of times showing the
new setting, stays
lit for two seconds
and then goes off.
Example) When
the setting is [3].
(Blinks three times)
(Lit two seconds)
Example) When the setting is [1].
( Blinks one time) ( Lit two seconds)
(Off/end)
Publicité
