Hilti SFC22-A Mode D'emploi page 30

2. Check that the connection end of the drill bit is clean. Clean
the connection end if necessary.
3. Insert the drill bit in the keyless chuck and then turn the chuck
firmly by hand until several clicks are heard.
4. Check that the drill bit is held securely.
en
7.5 Removing the drill bit
1. Set the forward / reverse switch to the middle position or
remove the battery from the power tool.
2. Open the keyless chuck.
3. Pull the insert tool out of the chuck.
7.6 Drilling
CAUTION
Use clamps or a vice to secure the workpiece. The workpiece
is thus held more securely than by hand and both hands remain
free to operate the power tool.
1. Turn the torque and operating mode setting ring to the drilling
symbol.
2. Move the forward / reverse switch to the "Forward" position.
7.7 Screwdriving
7.7.1 Fitting the bit holder / bit
1. Set the forward / reverse switch to the middle position or
remove the battery from the power tool.
2. Open the quick-release chuck.
3. Insert the bit adapter in the keyless chuck and then turn the
chuck firmly by hand until tight.
4. Check that the bit adapter is held securely (check by pulling).
5. Fit the bit in the bit holder.
7.7.2 Screwdriving
1. Select the torque function on the setting ring for torque and
drilling.
2. Set the forward / reverse switch to the desired direction of
rotation.
7.7.3 Removing the bit / bit holder
1. Set the forward / reverse switch to the middle position or
remove the battery from the power tool.
2. Remove the bit from the bit holder.
3. Open the keyless chuck.
4. Remove the bit adapter.
7.8 Reading the charge status LED display on Li­ion batter-
ies 6
NOTE
The charge status can not be indicated while the power tool is
in operation. LED 1 blinks when the battery is fully discharged
or when it is too hot (temperature above 80°C). The battery must
then be inserted in the charger.
The Li-ion battery features a charge status LED display. The
charge status is indicated by the LEDs on the battery during
charging (please refer to the operating instructions for the charger).
When the battery is not in use, pressing one of the battery release
buttons or inserting the battery into the power tool causes the
battery charge status to be displayed by the four LEDs for three
seconds.
8 Care and maintenance
CAUTION
Before beginning cleaning, remove the battery from the power
tool in order to prevent unintentional starting.
8.1 Care of insert tools
Clean off dirt and dust deposits adhering to the insert tools and
protect them from corrosion by wiping the insert tools from time
to time with an oil-soaked rag.
26
Printed: 05.09.2013 | Doc-Nr: PUB / 5071588 / 000 / 01