Publicité
¾Power plug. The effective absorbed current "I1 eff" is
indicated on the technical plate of the welding machine,
when it is used at maximum power. Connect the
welding machine to a normalized plug (3P+T 3Ph) of
capacity sufficient to deliver maximum power
Preparing the plasma cutting circuit
¾MANUAL CUTTING. Connect the hand cutting torch and
make sure the consumables are suitable for the job.
¾AUTOMATED CUTTING TABLE. Connect the automatic
cutting torch and make sure the consumables are suitable for
the job. Connect the equipment to the automated cutting table.
The interface kit with cuting table must be mounted on the
L
machine.
¾Connect the ground lead to the machine and to the workpiece
as close as possible to the area to be cut and in an area free
from rust, paint or dirt.
¾Connect the air fl ow regulator of the equpment to a suitable
source of compressed air capable to deliver at least 240L/
min at a pressure of 5,0 BAR (72 PSI) minimum.
Plasma cutting: controls and signals
Knob allows you to select the parameters present in the various
menu and to set the desired values. Press the knob to confi rm
your choise.
Browse through Views
Screenshot: HOME
A
B
A) Manual cutting.
B) Manual cutting on grid.
C) Gouging.
D) Automated cutting CNC.
M) Torch spare parts list.
R) General settings.
950059-01 24/05/05
Fig. 3,2.
M
R
C
D
Screenshot: CUTTING PARAMETER
E
F
G
H
I
E) Metal selection.
F) Metal thickness selection.
G) Cutting current selection.
H) Cutting speed selection.
I) Air pressure test.
Z)
Statusbar. Indicates the main adjustments in operation.
Y) Back to HOME view
Cutting process setup
After commissioning, switch on the machine.
Selection of the cutting process
In the "HOME" view, select the desired cutting process. The
equipment is ready for use with the last setting.
Manual cutting
¾In the "Cutting parameters" view, select the type of metal and
its thickness to have the correct cutting current and speed.
In manual cutting mode, a cutting current lower than the
L
maximum current and a lower speed are proposed. Obviously
all the parameters can be modifi ed according to the needs.
Manual cutting on metal grid
The arc can accidentally turn off while you are cutting sheet
metal grating.
Just hold the torch switch down until the machine switches on
again automatically.
¾In the "Cutting parameters" view, select the type of metal and
its thickness to have the correct cutting current and speed.
In manual cutting mode, a cutting current lower than the
L
maximum current and a lower speed are proposed. Obviously
11
Z
Y
Publicité
