Publicité
(3)Precautions before Installation
Confirmation Water pressure
The minimum dynamic operating water pressure is 25 Psi, and the
maximum static water pressure is 80 Psi.
Determination method for minimum water flow
(Tools: stopwatch,
measuring cup.)
Confirm dimensions of product with installation space
18.54"
Rough-in 12"
16
Open the angle valve for the water
supply. The measured water flow for
10 seconds should exceed 3L/0.8
gallon.
※ If the above conditions cannot be
met, the best flushing effect cannot
be achieved and an additional
booster pump is required to increase
the pressure.
15.78"
26.88"
4.Installation The Smart Toilet
(1) Draw a cross marker on the drain outlet on the ground.
● Clean the floor and wipe off any excess dust or dirt . Failure to
install on an cleaned surface will affect the quality of installation.
Existing water supply
angle valve
Drain outlet
Cross marker
(2) Installation of floor flange.
Ground Flange
(3) Install smart toilet bottom flange anchor screw.
● Turn the ceramic body over laterally and place on a prepared
foam surface. By visual measurement, draw a line on one lateral
side of the ceramic body point of the drain outlet perpendicular to
the plane against the central of ceramic bottom, and the same
for the other lateral side, and draw a line perpendicular to the floor
from the front central point of ceramic body.
Grounded waterproof and
splash-proof electrical outlet.
8" (200mm)
12" (305mm)
Marking Pen
17
Publicité
