Publicité
● Connect water filter to male thread on adapter (apply Telflon
tape to male threads).
Connect braided supply tubes to tee valve male connections.
- 1/2" seat water supply hose to bottom of tee valve
- 1/2" toilet water supply hose to right side of tee valve
Note: Use Telflon Tape on all threaded connections to insure a
water tight seal.
FIGURE 9C
(8) Confirm the water supply.
● Open the water supply angle
valve to the greatest extent as
shown in the drawing.
● Make sure there is no water
leakage in each connection
part. If there is water leakage,
please re-tighten the nut for
re-installation.
20
FIGURE 9D
(9) Connect the power supply.
● Connect the ground wire.
● Power plug into the AC 120V
socket.
● Confirm whether the power is
connected.
Note:
Check the power plug indicator
light. An illuminated power
indicator confirms that the smart
toilet is on. Once powered on,
press and hold the knob for 3
seconds to enter standby mode.
4. Install the Remote Control
(1) Install the Remote Control
1. According to the location of the screw holes of the remote
control holder, drill two holes with a 6mm-diameter drill bit on the
wall with a depth greater than 45mm.
2. Install the expansion tube into the holes.
3. Place the remote control holder onto the fixing hole.
4. Fix the remote control holder with the configured expansion
screws.
5. Open the battery area of the remote control and install new
batteries.
6. Place the remote control on its holder.The specific steps are
shown in the drawings below.
If the wall for installation is of a specific material (such as wood
panel, MDF), please use a suitable fixing method.
The remote control should be installed in a place that is not easily
exposed to water.
Installation steps:
45mm
Completion
of bracket
Screws
installation
Bracket
of remote
Anchor
controller
Placement
of remote
control
21
Publicité
