Publicité
- For a thin, smooth mix, if necessary, remove food from the side of the goblet (O) and bring it to the
centre using an apposite spatula, after having removed the motor body (D) and the lid (Q).
- To interrupt the operation, just release the speed button pressed (B-C). The appliance allows to
chop food in very short time.
FOOD PROCESSOR ATTACHMENT LID (only for Mod. 603)
The food processor can be used for chopping, slicing, mincing, grating.
WARNING
Before use, place the non-slip rubber ring (Y) on the goblet base (Fig. 8).
Chopping, mincing
- Fit the blade (U) on the shaft (X) of the food processor goblet (V), (Fig. 9).
- Cut food into small pieces (1.5 x 1.5 cm) and insert it into the container (V).
ATTENTION:
Do not insert food above the max level indicated on the goblet (V).
- Insert the lid (S) on the goblet (V): press the lid unlocking lever (Z) (Fig. 10) and at the same time
rotate the lid clockwise until the lid unlocking lever (Z), when released, locks on the reference notch
on the lid (Fig. 11).
- Place the motor body (D) in the apposite housing (T) on the lid (S), (Fig. 12). Rotate the motor
body clockwise until it clicks in place.
- Plug appliance in and start it by pressing the minimum speed button (B). Only after few seconds,
according to preparation and kind of food, it is possible to set a higher speed increasing it gradu-
ally by rotating the apposite top dial (A). According to use, it is possible to set also the max speed
"Turbo" by pressing the apposite button (C). The best performance of the appliance is achieved
through a pulse mode by pressing the button (B-C) for a very short time (2-3 seconds).
- If it is necessary to add ingredients during operation, use the opening on the lid (S). Press inserted
food using the food presser (R) (Fig. 13).
- To interrupt the operation, just release the speed button pressed (B-C). The appliance allows to
chop food in very short time.
- For a thin, smooth ground, if necessary, remove food from the side of the goblet and bring it to the
centre using an apposite spatula, after having unplugged it and having removed the lid (S).
- To remove the lid (S), press the lid unlocking lever (Z) by lifting it and at the same time rotate the
lid counter-clockwise.
WARNING
Blades are sharp, handle them with care.
To prevent personal injuries and appliance damages, always keep hands and kitchenware out
of operating blades and discs.
Make sure the lid is properly locked before starting the appliance.
Do not operate the appliance for more than continuous 30 seconds. Await at least 2 minutes
before proceeding with a new use.
- 17 -
EN
Publicité
