Publicité
INSTALLATION INSTRUCTIONS
C-HB-C-RD Series
FCC NOTICE
CAUTION: Changes or modifications not expressly approved could
void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-005 (A)/NMB-005 (A)
Fixture is equipped with universal volt driver 120-277V
NOTE: Make sure voltage range of fixture is compatible
with supply voltage.
Make the following Electrical Connections:
1. Connect the black fixture lead to the voltage supply
lead.
2. Connect the white fixture lead to the neutral supply
lead (Hot 2 for 208/240/480V wiring).
3. Connect the bare or green ground fixture lead to the
supply ground lead.
DIMMING
NOTE: If the motion sensor accessory is being used,
dimming will be controlled by the motion sensor. Make
sure violet and grey or pink dimming leads are capped off.
NOTE: If dimming is not being used, cap off the grey or
pink and violet leads from cord exiting top of fixture.
1. Pink (-) and violet (+) leads are for 0-10V dimming
systems. Cap off if not used.
2. For dimming connections, use Class 1 wiring
methods.
ELECTRICAL CONNECTIONS- NON-EMERGENCY UNITS
http://lighting.cree.com/warranty
Document
LPN00617X0001A3_A
Created By:
TMT
LINE
GREEN
NEUTRAL
OR HOT 2
DIM (+)
VIOLET
DIM (-)
GREY OR
PINK
|
866.924.3645
Date:
01-24-2024
LUMINAIRE
LINE-BLACK
BARE OR GREEN
NEUTRAL-WHITE
VIOLET
GREY OR PINK
Publicité
